ARM-USB-OCD

Qty

3-IN-1 FAST USB ARM JTAG, USB-TO-RS232 VIRTUAL PORT AND POWER SUPPLY 5-9-12VDC DEVICE (SUPPORTED BY OPENOCD ARM DEBUGGER SOFTWARE)

FEATURES

First on market three-in-one USB JTAG debugger - offers JTAG + RS232 (full modem signals supported) port + power supply all in one compact device
Fast speed USB 2.0 JTAG dongle interface, can be used with all ARM devices for programming and debugging.
uses ARM's standard 2x10 pin JTAG connector
supports ARM targets working in voltage range 2.0 – 5.0 V DC
software supported by Open OCD (open source) debugger
adds virtual RS232 port to your computer with all modem signals like: DTR, DSR, DCD, RTS, CTS, Rx, Tx
can be used as power supply to your target board with three jumper selectable power supplies: 5V 9V and 12VDC,
USB source current is limited with resetable fuse at 300mA, at the different output voltage the maximum current is
different: 5V/200mA, 9V/100mA, 12V/70mA, note that this also depend on your USB host current capabilities, if other
USB devices are attached to your computer or if the laptop is running on batteries these figures may be different and
depend on your computer USB host.
comes with CD with Windows installer for full featured and open source tools as alternative to the commercial ARM
development packages: GCC C compiler, openOCD debugger and Eclipse IDE.
Works with IAR EW-ARM 5.50 or newer

dimensions 50x40 mm (2x1.6") + 20 cm (8") JTAG cable + 30 cm (12") power supply cable

₹ 5,900.00